Siemens SIMATIC Ident Function Manual page 56

Error messages and troubleshooting
5.2 Error messages
Error code
(W#16#...)
56
8093 The area identifier contained in the configuration (SDB1, SDB2x) of the logical
address is not permitted for these SFCs. Permitted:
0 = S7-400
•
1 = S7-300
•
2, 7 = DP modules
•
80A0 Negative acknowledgment while reading from module. FB fetches acknowledgment
although no acknowledgment is ready.
A user who is not using FB 45 would like to fetch DS 101 (or DS 102 to104) although
no acknowledgment is available.
Perform an init_run for new synchronization between ASM and application.
•
80A1 Negative acknowledgment while writing to the module. FB sends command although
a CM is unable to receive a command
80A2 DP protocol error with layer 2
DP-V1 mode must be set in the header module for distributed I/O.
•
Possible hardware defect
•
80A3 DP protocol error in Direct-Data-Link-Mapper or User-Interface/User. Could be a
hardware defect.
80B0
SFC not possible for module type
•
Data record unknown to module
•
Data record number ≥ 241 is not allowed.
•
Data records 0 and 1 are not permitted for SFB 52/53 "WR_REC."
•
80B1 The length specified in the RECORD parameter is wrong.
80B2 The configured slot is not occupied.
80B3 Actual module type is not the module type specified in SDB1.
80B7 Incorrect length specified
80C0
RDREC:
•
The module has record, but it doesn't have any read data.
WRREC:
•
CM is not ready to receive new data
– Wait until the cyclic counter has been incremented
80C1 The data of the preceding write job on the module for the same data record have not
yet been processed by the module.
80C2 The module is currently processing the maximum possible number of jobs for a CPU.
80C3 Required resources (memory, etc.) are currently in use.
This error is not reported by FB 45. If this error occurs, FB 45 waits until the system
is able to provide resources again.
Description
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618