Siemens SIMATIC Ident Function Manual page 53

error_FB
Table 5- 3
Error code
(B#16#...)
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
Error variable "error_FB"
00 No error; default value if everything is ok.
01 Params_DB not available in SIMATIC
02 Params_DB too small
UDT 10/11 was not used during definition
•
Params_DB must be 300 bytes in length (for each channel)
•
Check that Params_DB and Params_ADDR are correct
•
03 The DB after the "command_DB_number" pointer is not available in the SIMATIC.
04 "command_DB" in the SIMATIC too small
UDT 20/21 was not used during command definition
•
The last command in "command_DB" is a chained command; reset the chaining
•
bit
Check command pointer command_DB_number/command_DB_address
•
05 Invalid command type. You will find a description of the valid commands in the
section "RFID commands (Page 29)".
Check command pointer command_DB_number/command_DB_address
•
Check the current values in command_DB
•
– Execute an init_run
06 Unexpected acknowledgement received. The parameters of the command and
acknowledgement frame do not match (command, length, address_MDS).
The user changed the command_DB_number/_address pointer during command
•
execution.
The user changed the command parameters in the MOBY CMD data block (UDT
•
20) during command execution.
Check the ASM_address and ASM_channel parameter settings. ASM_address
•
and ASM_channel have the same parameters for different channels.
The acknowledgement counter and command counter (see section "Cyclic
•
control word between master and communications module (Page 102)") between
the CM and FB are no longer synchronized
– Execute an init_run
07 The MOBY_mode or MDS_control parameter (defined in UDT 10) has an illegal
value (see Section "Parameter data block").
08 A bus error has occurred which is reported by system functions SFB 52/53. More
information on this error is available in the error_BUS variable.
ASM_address or ASM_channel not available
•
Execute an init_run
•
Error messages and troubleshooting
Description
5.2 Error messages
53