Siemens SIMATIC Ident Function Manual page 23

Variable
distance_limiting
MOBY D:
HF power from 0.5 W to 10 W in steps of 0.25 W
only effective for SLG D10S; a power of 1 W (04 hex) is set for SLG D11S / D12S and cannot be
changed.
02 hex = 0.5 W
:
10 hex = 4 W (default)
:
28 hex = 10 W
RF200:
00 hex (reserved)
RF300:
With this parameter, a change to the output power can only be made for the RF380R (order no.
6GT2801-3AB10). In doing this, you must take into consideration that the change to the output
power will affect both the upper and lower limit range, as well as the minimum distance that is to be
maintained between adjacent RF380Rs. Refer to the "RF300 system manual", section Field data
The following settings are possible:
Value
02
03
04
05
06
07
08
Settings outside of the specified values mean that the default value of 1.25 W is set and no error
message occurs for compatibility reasons!
MOBY U:
Range limitation
Normal output power
1)
multitag MOBY U/D, RF200 and RF300:
Maximum number of transponders being processed in the field at the same time.
Permitted values: 1
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
0.5 W
0.75 W
1.0 W
1.25 W
1.5 W
1.75 W
2.0 W
1)
05 hex = 0.5 m
0A hex = 1.0 m
0F hex = 1.5 m
14 hex = 2.0 m
19 hex = 2.5 m
1E hex = 3.0 m
23 hex = 3.5 m
Intermediate values in steps of 0.1 m are possible (02, 03, ..., 23 hex)
Description
Reduced output power
85 hex Reduced output power must be set when several readers
8A hex are positioned close together or when data memories
8F hex located in the vicinity of a reader are detected later or not
91 hex at all.
99 hex
Disadvantage: The field lobe becomes smaller and there
9E hex
is less time for communication or positioning must be
A3 hex
more precise.
Parameterizing
3.1 Parameter data block
23