Hardware Components; Software Requirements - Siemens SIMATIC TI505 User Manual

Hardware Components

Hardware
Components
WARNING
!
Software
Requirements
1-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The remote I/O for the Redundant I/O system consists of a Hot Backup
installation, plus the following components for each Series 500 redundant
I/O base.
Two PPX:500–2114A Remote Base Controllers (RBCs)
Two power supplies: PPX:500–2151A 110/220 VAC or
PPX:500–2153 24 VDC
PPX:500–5864, 8-slot base or PPX:500–5828, 16-slot base
PPX:500–9940 Redundant Controller Adapter Chassis
User-supplied cables, grounding materials, and taps
To help avoid potential for personal injury or damage to equipment, do not
use PPX:500–2151 power supply or non-dual RBCs with a PPX:500–9940A
adapter chassis in a redundant I/O configuration. Do not use the
PPX:505–6660 power supply in a redundant I/O configuration. To do so may
cause improper operation of your system.
Use the following components for a Series 505 redundant I/O base.
Two PPX:505–6850A Remote Base Controllers (RBCs)
Two power supplies: PPX:505–6660A 110/220 VAC or
PPX:505–6663 24 VDC
PPX:505–6511, 11-slot base
User-supplied cables, grounding materials, and taps
You must have Release 2.1 or greater of RCC, CPU, SFCPU, and HBU
software. You can use either the dual RBC or dual power supply in single
mode operation with any RCC software releases. Non-dual RBCs can be
used with any RCC.
NOTE: With earlier software releases, a redundant I/O base with dual RBCs
causes the RCC to fail that base.
SIMATIC TI505 Redundant I/O System User Manual