Siemens SIMATIC PG 760 Manual page 4

Introduction
Plan of the Text This manual contains the most important instructions for commissioning and
using the PG 760 required in special situations.
Setting up and getting to know your device
Before you start to use your programming device, you should read about
setting up the device in Chapter 2 and about the components and functions of
the PG 760 in Chapter 3.
Installation
Chapter 3 describes the basic steps necessary for starting up the PG 760. This
chapter also contains instructions for working with SIMATIC memory cards
and for connecting the programming device to other devices.
Expansion
Chapter 4 describes how to expand your PG 760 (for example installation of
memory expansions). Please observe the safety instructions in this section.
Configuration
Modifications made to the system hardware may make it necessary for you to
adapt the original hardware configuration. This is described in Chapter 5.
Error/fault diagnostics
Chapter 6 explains how to deal with simple faults and problems that you can
diagnose and, in some cases, eliminate yourself.
Reference data
Chapter 7 contains information about hardware addresses, interrupt
assignments and connecting cables.
Glossary
The glossary defines and explains important terms.
Alphabetical index
The alphabetical index will help you to find passages in the text relating to
important terms quickly and reliably.
Queries
If you have any questions concerning subjects not covered in the manual,
simply get in touch with the Siemens representative in your area. The
addresses for the maintenance and repair centers and the SIMATIC hotline
can be found in the Product Information Bulletin.
If you have any questions about the manual itself or would like to make any
suggestions, please complete the remarks form at the end of the manual. We
would also appreciate it if you would include your own opinion and appraisal
of the manual on the remarks form.
iv
PG 760 Programming Device
C79000-G7076-C761-01