Table of Contents
Advertisement
8. Select the COM port which the VC-101 is connected to.
9. Press "OK" button.
10. Repeat steps 1 to 9 for another VC-101.
11. Disconnect the console cable from VC-101 and PC
COM port when finished.
To verify the new setting:
I. Connect the VC-101M and VC-101S and make sure they
are linked. (If connection does not establish might due to
distance restriction or environment factors)
II. Connect the VC-101M and a PC through console port via
console cable. (DB-9 to DB-9 cable)
III. Launch terminal application and set its settings to:
Baud Rate: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
IV. Once connect you will be able to see the command
prompt L>
Observe: "L>" represents the command prompt at
VC-101M(local modem, the console cable connected unit is
consider the local one), to toggle to the VC-101S(remote
modem), press [CTRL+E] on the keyboard, you should see
23
Advertisement
Table of Contents
