Power Module - Fujitsu F2MC-8FX Series Application Note

3.4.2 Power Module

EV-board provides 2 kinds of power supplies for user to choose. Please read the following
instructions before using.
DC Adaptor: 5V DC:
Output voltage: 3.3V
Connection: Connector (J1)
Battery:
QTY: 4PCS;
Model: AA;
Nominal voltage: 1.5V.
Connection: Socket for Battery
If any of the power supplies is connected to the EV-board correctly, power LED6 on the EV-
board will be on. Refer to Figure 3-3.
The following two power supplies are recommended. Please follow the settings below.
Power supply
4 AA batteries from BT1
on the back of the EV-
board.
5V DC from J1
MB2146-460-E Setup Guide V1.2
Chapter 3 EV-board Manual
Figure 3-3: Power Module
Table 3-2: Selection of Power Supply
Header name
BAT.
5V.
MCU-AN-500083-E-12 – Page 17
Settings
5V
5V