Network Type; Recall Type; Operator Type; Changing Service Codes - Philips TD6736/BH051P User Manual

Reglages 19/04/01 14:44

Network type

Under the "Line settings" heading in the
1
"Settings" menu, select OK| to change the
network type.
Scroll to select the network you want and
2
select OK|.

Recall type

This function is only available if you have chosen the PABX-type network (see above).
Go to "Recall type" under the "Line settings"
1
heading in the "Settings"menu and select OK|.
Scroll to choose the flash length select OK|.
2
Selecting the Operator type
If you have subscribed to a caller identification service, your ONIS 200 will display the number of
the caller.
If your ONIS 200 does not display the caller's number, it may be possible that the operator type set by
default, does not correspond to your telephone operator.
In this case, 4 other caller identification settings are available to solve this problem.
To modify the operator type, use the following procedure:
Go to "Operator type" under the "Line
1
settings" in the "Settings"menu and select
OK|.
Scroll to select the Operator type you want
2
and select OK|.

Changing service codes

The ONIS 200 comes with pre-programmed service codes (key sequences).
You may access the codes if your operator uses different codes.To do this, use the "Service Codes"
menu.
L NOTE:
You can obtain the letter "R"of a code by pressing the
The letter "P" (pause) can be obtained by pressing and holding the
Page 43
Network type:
√
Public
BACK
Recall type:
√
Long flash
BACK

Operator type:

√
Type 1
BACK
key.
key.
Settings
OK
OK
OK
43