Table of Contents
Advertisement
Installing the AppController
Wire the Rnet +, Rnet -, and Gnd terminals on the controller's Rnet port to the terminals of the same name on
4
the Wireless Adapter's Rnet connector.
NOTE If using shielded wire, connect the shield wire and the ground wire to the Gnd terminal.
Wire the 24 Vac external power supply to the Wireless Adapter's power connector.
5
Mount the Wireless Adapter by inserting 2 screws through the mounting tabs on each end of the Wireless
6
Adapter.
Apply power to the external power supply.
7
Verify that the LED on top of the Wireless Adapter is blinking. See "LED" below.
8
Turn on the controller's power.
9
LED
The blue LED on the top of the Wireless Adapter indicates the following:
If the LED is...
Off
Blinking
Steadily on
AppController
Installation and Start-up Guide
Then the device...
Is not powered or there is a problem.
Is working properly.
Has a problem. Do one of the following:
Cycle power to the device.
Insert a small screwdriver or paper clip into the hole next to the LED to reboot the
device.
14
CARRIER CORPORATION ©2019
All rights reserved
Hide quick links:
Advertisement
Table of Contents
