Toyota Previa Owner's Manual page 95

1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in the
desired station (see "TUNE"). Push and
hold down the button until you hear a
beep—this will set the station to the but-
ton. The button number will appear on the
display.
To tune in to a preset station: Push the
button for the station you want. The button
number and station frequency will appear
on the display.
These systems can store one AM and one
FM station for each button. The preset
station memory will be canceled out if the
power source is interrupted (battery dis-
connected or fuse blown).
(Eject Button)
Push this button to eject a cassette.
After you turn the ignition to "LOCK", you
will be able to eject a cassette but you will
not be able to reinsert it.
90
AM FM
Push "AM FM" to switch between the AM
and FM bands. "AM" or "FM" will appear
on the display.
If the audio system is off, you can turn on
the radio by pushing "AM FM". Also, push
the "AM FM" button to switch from cas-
sette operation to radio operation.
BAL (Balance)
This knob lets you adjust the balance be-
tween the right and left speakers.
Pull out "PWR/VOL/BAL'. Turn the knob
to adjust the balance. Push the knob back
into its normal position.
BASS
This knob lets you adjust the bass level.
Push "BASS/TREB" so that it pops out of
its retracted position. Turn the knob to ad-
just the bass. Push the knob back into its
retracted position.
Dolby NR*
If you are listening to a tape that was re-
corded with Dolby Noise Reduction,
push the button marked with the
double-D symbol.
The double-D symbol will appear on the
display. Push the button again to turn off-
Dolby NR. The Dolby NR mode reduces
tape noise by about 10 dB. For best sound
reproduction, play your tapes with this
button on or off according to the mode
used for recording the tape.
*
: Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation. "DOLBY" and the
double-D symbol are trademark of Dolby Laboratories Licens-
ing Corporation.
FADE
Move the "FADE" ring around "PWR/
VOL" to adjust the front/rear balance.
PROG (Program)
Push "PROG" to select the other side of
a cassette tape. The display indicates
which side is currently selected ( " " indi-
cates top side, " " indicates bottom side).
Auto-reverse feature—After the cassette
player reaches the end of a tape side, it
automatically reverses and begins to play
the other side. This is true whether the
cassette was playing or fast forwarding.
PWR/VOL (Power/Volume)
Push "PWR/VOL" to turn the audio sys-
tem on and off. Turn the "PWR/VOL" knob
to adjust the volume.