Fuses (5:A); Assistance And Repairs; Storage; Terms Of Purchase - Stiga XK 140 HD Operator's Manual

(Translation of the Original Instructions)
Object Action
Centre 4 grease nipples
point Use a grease nipple filled
with multi-purpose grease.
Pump until the grease
seeps out.
Steering Brush the chain clean
chains with a wire brush.
Lubricate with universal
chain spray.
Tensioning Lubricate the support
points with oil
arms
when each control is
activated.
Ideally this operation
should
be carried out by two
people.
Control Lubricate the cable ends
with oil
cables
when each control is
activated.
This operation must be
carried out by two people.

9.13 FUSES (5:A)

Destination
Electrical system power supply 20 A

10 ASSISTANCE AND REPAIRS

This manual provides all the necessary infor-
mation to run the machine and for correct basic
maintenance operations which can be performed
by the user.
Any regulations and maintenance operations not
described herein must be carried out by your De-
aler or Authorized Service Centre, which have the
necessary knowledge and equipment to ensure
that the work is carried out correctly, maintaining
the correct degree of safety and the original opera-
ting conditions of the machine.
Before performing any servicing opera-
tions:
a. Place the machine on a flat surface.
b. Activate the parking brake (12:B)
c. Stop the engine.
d. Remove the key from the ignition.
Authorized service workshops carry out guaran-
ENGLISH
Fig.
30A
-
30B
30C
Fuse
teed repairs and maintenance.
Always use genuine spare parts.
Genuine STIGA SpA spare parts and
accessories were designed specifically
for STIGA SpA machines.
Please remember that non-genuine
spare parts and accessories have not
been verified or approved by STIGA
SpA.
The use of non-genuine spare parts
and accessories could adversely affect
machine operation and safety.
STIGA SpA shall decline all liability in
the event of injuries or damages caused
by such parts.
Genuine spare parts are supplied by
authorized assistance workshops and
dealers.
It is advisable to send your machine
once a year to an authorized service
workshop for servicing, assistance and
safety device inspection.

11 STORAGE

1. Empty the fuel tank:
• Start the machine's engine and leave it
running until it stops.
2. Change the oil when the engine is still warm.
3. Thoroughly clean the whole machine. It is
particularly important to clean the bottom
side of the cutting device.
4. If the paintwork is damaged, touch it up to
prevent rust.
5. Place the machine in a covered, dry place.
For machines with electric starter:
If the storage temperature is correct, simply
recharge the batter every four months.
Charge the battery before putting the
machine into storage.
The battery can be seriously damaged it if is
put into storage flat.

12 TERMS OF PURCHASE

The warranty covers all material and manufactu-
ring defects.
The user must follow all the instructions provided
in the accompanying documentation.
The warranty does not cover damages caused by:
• failure to become familiar with the
EN
23