Nokia N80 Manual page 97

9244700_N80-1_en_zh.book Page 95 Thursday, March 23, 2006 2:34 PM
Call waiting—If you have activated call waiting (network
service), the network notifies you of a new incoming call
while you have a call in progress. Set the function on
(Activate) or off (Cancel), or check whether the function
is activated (Check status).
Reject call with SMS—Select Yes to send a text message
to a caller informing why you could not answer the call.
See "Answer or decline a call", p. 64.
Message text—Write a text to be sent in a text message
when you reject a call.
Image in video call—If video is not sent during a video call,
you can select a still image to be displayed instead.
Automatic redial—Select On, and your device makes a
maximum of 10 attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialing,
press .
Summary after call—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
Speed dialling—Select On, and the numbers assigned to
the speed dialing keys ( -
pressing and holding the key. See also "Speed dial a phone
number", p. 60.
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any keypad key,
except ,
Line in use—This setting (network service) is shown only
if the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line.
If you select
network service, you will not be able to make calls.
When line 2 is selected,
Tip! To switch between the phone lines, press and
hold
Line change—To prevent line selection (network service),
select Disable
this setting, you need the PIN2 code.
Connection
Data connections and access points
) can be dialed by Your device supports packet data connections (network
service), such as GPRS in the GSM network. When you use
your device in GSM and UMTS networks, multiple data
connections can be active at the same time, and access
points can share a data connection. In the UMTS network,
data connections remain active during voice calls.
, , and .
Line 2 and have not subscribed to this
is shown in the standby mode.
in the standby mode.
if supported by your SIM card. To change
95