Nokia N80 Manual page 100

9244700_N80-1_en_zh.book Page 98 Thursday, March 23, 2006 2:34 PM
Authentication type—Select
authentication type between your device and the wireless
LAN access point device.
WEP key settings—Enter WEP encryption
key), WEP key format (ASCII
key (the WEP key data in the selected format).
Security settings for 802.1x
WPA mode—Select the means of authentication:
use an extensible authentication protocol (EAP) plug-in,
or Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP)—Enter the settings as
your service provider instructs.
Pre-shared key (only for Pre-shared
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption (only for WPA/WPA2)—Select whether
Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings
following:
IPv4 settings: Phone IP address
your device), Subnet mask (the subnet IP address),
Default gateway (the gateway), and
98
Open or Shared for the the IP addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
IPv6 settings
(length of the Well-known, or
or Hexadecimal), and WEP
Ad-hoc channel
number (1-11) manually, select
and WPA/WPA2:
Proxy serv.
EAP to server.
Proxy port
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data
key)—Enter a
are in a network that supports packet data, the device
registers to the packet data network. Starting an active
packet data connection (for example, to send and receive
e-mail) is quicker. If there is no packet data coverage,
the device periodically tries to establish a packet data
connection. If you select
packet data connection only if you start an application or
and from the
action that needs it.
Access
(the IP address of
device as a packet data modem to your computer.
DNS address—enter
> DNS address—Select Automatic,
User defined.
(only for Ad-hoc)—To enter a channel
User defined.
address—Enter the address for the proxy
number—Enter the proxy port number.
conn.—If you select When available
When needed, the device uses a
point—The access point name is needed to use your
and you