Advertisement
Fault 故障
1. No Ignition
點火不著
2. Flame cannot be held
不能保持火焰
3. No main fl ame
爐頭沒有火
4. Yellow fl ame
黃火
5. Unstable fl ame
火焰不穩定
RB-12S-C.indd Sec1:6
RB-12S-C.indd Sec1:6
TROUBLE SHOOTING MANUAL FOR BUILT-IN HOB
嵌入式雙頭爐的故障檢查手冊
Cause 原因
Spark electrode is wet especially in
seasons of high humidity.
點火電極 ( 瓦咀 ) 濕了 , 尤其是在潮
濕季節。
Incorrect turning of gas control
knob.
不正確轉動爐掣。
3.1 Gas meter cock and/or appliance
cock have been turned off.
仍未開啟氣錶控制閥及 / 或爐具
切斷閥。
3.2 Burner head is blocked
aluminium foil.
錫紙阻塞爐頭。
Accumulated grease and dirt on
head.
爐頭積聚油漬和污垢。
Incorrect location of burner head.
爐頭未放好。
Dry the electrode with tissue or dry
cloth.
以紙巾或乾毛巾抹乾點火電極
( 瓦咀 ) 。
Push and turn the gas control knob
anti-clockwise until a 'click' sound is
heard. Hold for a few seconds fl ame is
ignited.
推 入 爐 掣 及 反 時 針 方 向 旋 轉 至
「開」位置 , 直至聽到「的」聲。當
爐火點著時 , 按著爐掣數秒才放手。
Open gas meter cock and/or appliance
isolating cock completely.
完全開啟氣錶控制閥及 / 或爐具切斷
閥。
by
Remove aluminium foil.
拿去錫紙。
Wash burner head in warm water with
detergent. Dry it and place it back at
correct position.
以暖水和洗潔精清洗爐頭。把它抹
乾 , 然後放好。
Refi t burner head into burner body.
重新放好爐頭。
– 6 –
Remedy 處理方法
2/10/2009 9:30:51 AM
2/10/2009 9:30:51 AM
Advertisement
