Advertisement
* If another built-in appliance (e.g. dishwasher, washer, etc,) is to be installed under the built-in hob, keep a
clearance of at least 10mm from the bottom of the built-in hob. If the installation of the appliance underneath
requires a different distance, adopt the larger value.
若在嵌入式平面爐下安裝其他器具 ( 如洗碗碟機﹑洗衣機等 ) 。請保留最少 10 毫米的距離。
若其他器具的安裝指引要求不同的間距 , 應採用較大者。
* The built-in hob should be installed with a distance of more than 15cm away from surrounding combustible
materials.
此爐具的安裝位置應與週圍易燃物料距離 15 厘米以上。
* If the built-in hob is to be installed on top of a built-in oven, a partition between two appliances is required
with all gaps being sealed. It is to avoid the infl uence of air draught on the operation of the built-in hob
when the oven fan is running.
煮食爐下方如設有嵌入式焗爐 , 必須加裝隔層板並將所有縫隙密封 , 避免焗爐的風機氣流影響煮
食爐運作。
* In case that a partition plate is installed underneath the appliance, keep space by at least 10 cm in between.
若隔層板被安裝在器具下，請確保保持至少 10 釐米的空隙。
* Make sure that the following parts are fi tted properly before use:
使用前請確定以下配件已置於正確位置 :
1. Pan Support 爐架
Fit Pan Support into Glass Top Plate.
爐架正確地安放於玻璃面板上。
2. Burner Head, Burner Body 爐頭 , 爐體
Set back holes of Burner Body with Electrode Fixing place.
Then insert Burner Head Pin to top holes of Burner Body.
將爐體後的開孔對準點火針安裝位置。然後將爐頭腳插入爐體面上的
插孔。
Sparks Electrode
Burner Head-S
爐頭 - S
Fit Burner Head into Burner Body properly without gap. See the right illustration as below.
爐頭放置在爐體上 , 放置時請勿傾斜。 如下圖。
RB-12S-C.indd Sec1:3
RB-12S-C.indd Sec1:3
點火針
Safety Sensor
安全感應頭
Gap
空隙
Sparks Electrode
點火針
Safety Sensor
安全感應頭
– 3 –
Burner Head-SS
爐頭 - SS
Gap
空隙
2/10/2009 9:30:49 AM
2/10/2009 9:30:49 AM
Advertisement
