Set Mono Or Left Only Mode - Telex Ascend Series Manual

Set Mono or Left Only Mode

Audio on the headset can be configured to be heard either Mono or Left Only. This means it can come from both sides of the
headset or from the left side only. This configuration is done through setting dip switches located on the interface module.
Dip Switch Settings
NOTE: The two (2) left-most switches are used to configure mono or left only operation.
To configure mono or left only on the headset, do the following:
Using Table 2 on page 19, set the dip switches to the mode of operation desired.
>
Mono or Left Only Dip Switch Settings
TABLE 2.
Dip Switch Description
Mono Mode
Left Only Mode
19