Preparing The System For Operation - IBM Power System 9040-MR9 Manual

Figure 77. Replacing the fans
Preparing the system for operation after removing and replacing the system backplane
from the 9040-MR9
To prepare the system for operation after removing and replacing the system backplane, complete the
steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Complete the following steps to place the system in the service position.
Do not pull out or install any drawer or feature if the rack stabilizer brackets are not attached to the
rack. Do not pull out more than one drawer at a time. The rack might become unstable if you pull out
more than one drawer at a time.
76 Power Systems: System backplane