Siemens Sinamics G120P Instruction Manual page 43

Function buttons
You can operate the motor using the function buttons. The HAND/AUTO button changes the command
source between the BOP-2 (HAND) and field-bus or terminal (AUTO). A symbol of a hand appears on
the screen to indicate that the HAND mode is active.
• In the HAND mode, the ON and OFF buttons are enabled
• In the AUTO mode, the ON and OFF buttons are disabled
• If the HAND mode is active, pressing the HAND/AUTO button will switch the converter to the AUTO
mode
• If the AUTO mode is active, pressing the HAND/AUTO button will switch the converter to the HAND
mode
• Changing from the HAND to the AUTO mode is possible while the motor is running
Screen icons
The BOP-2 displays a number of icons at the left-hand side of the display to indicate the actual state
of the converter.
• Command source, auto / hand
• Converter status, operational
• JOG
• Fault / alarms active
JOG
A detailed list of the fault and
alarm messages can be found in
the "Parameter Manual: Control
Units – CU230P2" as a download
at: http://support.automation.
siemens.com/WW/view/
en/49946106
NOTE
31