Table of Contents
Advertisement
In the DYNAMIC riding mode,
7
ABS Pro is only available with
good friction coefficients. As-
114
sistance is less than in the
ROAD riding mode and de-
signed for maximum braking
effect instead.
In the Enduro riding mode,
ABS Pro is available only to a
restricted extent and also only
with good friction coefficients.
In the Enduro Pro riding mode,
ABS Pro is inactive.
ASC
The front wheel lift assistant is
active in all riding modes.
z
In the RAIN, ROAD and DY-
NAMIC riding modes, the ASC
is set up for road riding.
In the Enduro and Enduro Pro
riding modes, ASC is set up for
off-road riding.
OE
with Dynamic ESA
Dynamic ESA
In the RAIN, ROAD and
DYNAMIC riding modes, the
damping variants HARD,
NORMAL and SOFT can be
selected.
Basic setting RAIN: SOFT
Basic setting ROAD: NORMAL
Basic setting DYNAMIC: HARD
In the Enduro and Enduro Pro
riding modes, the damping vari-
ants HARD and SOFT can be
selected.
Basic setting Enduro: SOFT
Basic setting Enduro Pro:
HARD
Mode changes
with Pro riding modes
When riding, you can change rid-
ing modes only when the follow-
ing preconditions are satisfied:
No drive torque on the rear
wheel.
No brake pressure in the brake
system.
This is the status of the motor-
cycle when it is at a standstill
with the ignition switched on.
Under other circumstances, you
must proceed as follows:
Close the throttle twistgrip.
Release the brake levers.
Disengage the clutch.
The desired riding mode is ini-
tially preselected. The mode
change does not take place until
the systems in question are all in
the appropriate state.
The selection menu does not
OE
disappear from the display un-
til the mode change has taken
place.
Advertisement
Table of Contents
