Rinsable Attachments; Storage; Replacing Trimmer Cutting Unit - Philips Norelco G370/65 User Manual

◗
The shaving foil is very delicate and should not
be handled.
◗
If foil becomes damaged, replace it. Do not
apply pressure to shaving foil.
5 Do not clean the foil with the brush, as this
may cause damage.
6 Place the attachment back on the Groomer
or place it in the storage stand.

Rinsable Attachments

◗
If preferred your Groomer trimming
attachments (See Features ) can also be rinsed
clean after each use.
1 Remove any attachment from groomer and
rinse attachment only thoroughly under warm
tap water(fig.29).
Never rinse attachments that are still attached to
the Groomer.
2 Shake excess water from attachment (fig. 30)
and allow to dry thoroughly.
Do not use a towel to air dry the mini shaver as
damage to the shaving foil could occur.
3 Place the attachment back on the Groomer
or place it in the storage stand.
This Groomer has no other user-serviceable parts.
Any other service should be performed by the
Philips Norelco Service Location.

Storage

◗
Be sure Groomer is turned OFF. Remove cord
from outlet and Groomer before storing in a
safe, dry location where it will not be crushed,
banged, or subject to damage.
◗
Store the Groomer and attachments in the
storage stand to prevent damage.
◗
Do not wrap cord around Groomer or stand
when storing.
◗
Store cord in a safe location where it will not
be cut or damaged.
◗
Do not place or store Groomer where it can
fall or be pulled into a tub or sink, water or
other liquid while plugged in.

Replacing Trimmer Cutting Unit

If your cutters become damaged or worn, do not
continue using the Groomer. Cutters should be
replaced immediately by the Philips Norelco
Service Location.