Beard Trimmer - Philips Norelco G370/65 User Manual

◗
If you are trimming for the first time, start by
using the AccuControl comb at the maximum
trimming length setting (#9) to prevent acci-
dentally trimming hairs too short. As you
become familiar with the settings, adjust Hair
Length Selector to desired trimming length.
Selector will "click" into position at each
setting.
3 Switch the Groomer ON.
4 To trim in the most effective way, move the
Groomer against the direction of hair
growth. Make sure the surface of the Guide
Comb always stays in contact with the skin
(fig. 8).
NOTE: Since all hairs do not grow in the same
direction, you may want to try different trimming
directions (i.e., upwards, downwards, or across).
Practice is best for optimum results.
◗
If a lot of hair has accumulated in the Guide
Comb, remove the comb and blow and/or
shake the hair out of the comb.You can also
use the cleaning brush provided to remove
hair from the comb area.
◗
REMEMBER:You must reset the hair length
selector back to your desired setting every time
you replace the guide comb on the appliance.
Table 1. Beard Trimmer
Setting
1 Stubble
2 Closely Cropped
3 Short
4 Medium Short
5 Medium
6 Medium Long
7 Long
8 Extra Long
9 Longest
◗
The remaining hair length corresponds with
the smallest distance between the cutting
blade and the spot where the comb is in contact
with the skin.
◗
Cutting without the comb attachment or
setting the AccuControl guide comb to #1
position will result in a stubble beard look.
Remaining hair length
(in.) /(mm)
.08 in/2mm
.16 in/4mm
.24 in/6mm
.31 in/8mm
.39 in/10mm
.47 in/12mm
.55 in/14mm
.63 in/16mm
.71 in/18mm