Installing The 7002 Cable - IBM e Server i Series Setting Up

Installing the 7002 cable

If your system unit came with the 7002 internal flex cable, you need to install it before you can set up
your unit. To install the 7002 cable follow these steps:
__ 1. Remove the right side cover (view from back):
__ a. Loosen the screws.
__ b. Slide the cover from front to back until it stops.
__ c. Pull the cover out.
Figure 4. Remove system unit side cover
Your system unit contains a battery that only trained personnel can replace.
CAUTION:
The battery is a lithium battery. Only trained service personnel may replace this battery using the
instructions in the Problem Analysis, Repair, and Parts service manual. To avoid possible explosion,
do not burn or charge the battery. Exchange only with the IBM-approved part. Discard the battery as
instructed by local regulations. (RSFTC241)
8
Setting up your 0588, 0595, 5088, 5094, 5095 or 5294 Expansion Unit V5R3