Installing The Cable-Management Arm - IBM S812L Installing

2
3
1
Figure 7. Extending slide rails and aligning server nail heads with the slots on the rail
3. Lift the blue release latches (1) on the slide rails and push the server (2) all the way into the rack until
it clicks into place.
Figure 8. Install the server into the rack

Installing the cable-management arm

The cable-management arm is used to efficiently route cables so that you have proper access to the rear
of the system. Use the procedure to install the cable-management arm.
To install the cable-management arm, complete the following steps:
1. Ensure that you have the following parts.
4
5
1
2
Item Description
A
Support arm
B
Cable-management stop bracket
C
Mounting bracket
D
Cable-management arm
E
Extension bracket
Installing the IBM Power System S812L (8247-21L)
7