Installing Packages - NEC Express5800 Series Installation Manual

Chapter 1 Installing Operating System

2.2.3 Installing Packages

Take the steps below to install packages in ft Server Control Software and NEC ESMPRO Agent.
1. Login the system with root user. If you login with graphical mode, select [Others...] to login.
2. Set the ft Server Control Software Install CD to optical disk drive. After a while, the drive will be
automatically mounted.
3. Run the following command to copy files.
# /bin/cp -f /media/FT905380/ftsys/RHEL6.5/pkginst.sh /tmp
4. Run the following command to unmount the media.
# umount /dev/cdrom
5. Remove the ft Server Control Software Install CD from optical disk drive, and insert the install media
of Red Hat Enterprise Linux 6.5. After a while, the media is automatically mounted.
6. Run the following command to install the package.
# /tmp/pkginst.sh
7. When installation completes, the following message is displayed.
The install has completed.
8. Run the following command to unmount the media.
# umount /dev/cdrom
9. Remove the install media of Red Hat Enterprise Linux 6.5 from optical disk drive.
40
In this section, description is based on the assumption that the optical disk drive has been
Tips
mounted automatically. If the optical disk drive is not mounted automatically depending on
your environment, mount it on the desired location manually. If the mount destination
differs, substitute it for the actual destination appropriately.
Express5800/R320c-E4, R320c-M4 Installation Guide (Linux)
2. Setting up Red Hat Enterprise Linux 6 Server