Group 3.6: Fieldbus Data Mapping - Siemens BT300 Applications Manual

Siemens Industry, Inc. • 46
3.5.7.6 Expander slots D to E analog outputs
Code Parameter
Application dynamic
output list
3.5.8

Group 3.6: Fieldbus Data Mapping

Code Parameter
Fieldbus data out 1
P3.6.1
selection
Fieldbus data out 2
P3.6.2
selection
Fieldbus data out 3
P3.6.3
selection
Fieldbus data out 4
P3.6.4
selection
Fieldbus data out 5
P3.6.5
selection
Fieldbus data out 6
P3.6.6
selection
Fieldbus data out 7
P3.6.7
selection
Fieldbus data out 8
P3.6.8
selection
Fieldbus process data out
Values to monitor through fieldbus are:
Process Data Out 1
Process Data Out 2
Process Data Out 3
Process Data Out 4
Process Data Out 5
Process Data Out 6
Process Data Out 7
Process Data Out 8
Table 34: Slot D/E analog outputs.
Min Max
Table 35: Fieldbus data mapping.
Min Max
0 35000
0 35000
0 35000
0 35000
0 35000
0 35000
0 35000
0 35000
Table 36. Fieldbus Process Data Out.
Data
Output frequency
Motor speed
Motor current
Motor torque
Motor power
Motor voltage
DC-link voltage
Last active fault code
Unit Default
Unit Default ID
1 852
2 853
45 854
4 855
5 856
6 857
7 858
37 859
Value
0.01 Hz
1 rpm
0.1 A
0.1 %
0.1 %
0.1 V
1 V
24-hour support +1-800-877-7545 (Dial 2)
Siemens Application
ID Description
Shows only parameters for
existing outputs in slot D/E.
Selections as in Basic AO1
Not visible if no analog out-
put exists in slot D/E.
Description
Data sent to fieldbus can be
chosen with parameter and
monitor value ID numbers.
The data is scaled to
unsigned 16-bit format
according to the format on
keypad. E.g. 25.5 on keypad
equals 255.
Select Process Data Out with
parameter ID.
Select Process Data Out with
parameter ID.
Select Process Data Out with
parameter ID.
Select Process Data Out with
parameter ID.
Select Process Data Out with
parameter ID.
Select Process Data Out with
parameter ID.
Select Process Data Out with
parameter ID.
Scale