Routine Maintenance Instructions - Baxi Luna 3 Silver Space Series Operating & Installation Instructions Manual

BLOCK
Block errors are signalled on the display with
and a flashing >>>OK message alternating (about
every 2 seconds) with the flashing message <ER-
ROR>.
The block is identified by an error code followed by
the letter E.
Press OK to reset the electronic board and resume
operation.
The display shows <RESET> and then >>>OK.
CODE
01E Ignition failure
02E
Safety thermostat tripped
03E
Flue thermostat/ flue pressure switch tripped
04E Safety error due to frequent flame loss
05E Delivery sensor fault
06E DHW sensor fault
10E Hydraulic pressure switch block
Safety thermostat for low temperature system cuts
11E
in (if connected)
18E System water filling in progress
19E System filling fault
25E Pump faulty or air in system
Communication error between electronic board and
31E
remote control unit
35E Parasite flame (flamer error)
80E Internal error in remote control unit
96E Internal error in remote control unit
97E
Electronic board input frequency (Hz) incorrectly set Change the frequency (Hz) setting.
98E
Internal card error
99E Internal card error

10. ROUTINE MAINTENANCE INSTRUCTIONS

To keep the boiler efficient and safe, have it checked by the authorised Service Centre at the end of every operating period.
Careful servicing ensures economical operation of the system.
Do not clean the outer casing of the appliance with abrasive, aggressive and/or easily flammable cleaners (e.g.: petrol, alcohol, and
so on). Always switch off the appliance before cleaning it (see section 6 "Switching off the boiler").
INSTRUCTIONS FOR USERS
ERROR
54
CORRECTIVE ACTION
Press OK. If this fault persists, call the Authorised Service Centre.
Press OK. If this fault persists, call the Authorised Service Centre.
Call the Authorised Service Centre.
Call the Authorised Service Centre.
Call the Authorised Service Centre.
Call the Authorised Service Centre.
Check that the pressure in the system is correct; See section 5.
If this fault persists, call the Authorised Service Centre.
Call the Authorised Service Centre.
Wait for filling to finish.
Call the Authorised Service Centre.
Call the Authorised Service Centre
Press OK. If this fault persists, call the Authorised Service Centre.
Press OK. If this fault persists, call the Authorised Service Centre.
Call the Authorised Service Centre.
Call the Authorised Service Centre.
Call the Authorised Service Centre.
Call the Authorised Service Centre.
925.523.1 - EN