Bosch GCM12SD Operating/Safety Instructions Manual page 27

2610051827 GCM12SD 08-18.qxp_GCM12SD 9/19/18 2:52 PM Page 27
45° Bevel Stop – Adjustment Procedure
power source before performing any assem-
bly, adjustment or repair.
Adjusting 45° Bevel Stop
(Saw Blade 45° to Table)
1. Pull up the bevel lock lever to unlock. Move
the left sliding fence fully to the left.
2. Tilt the saw assembly to the left (counter-
clockwise) until it hits the 45° stop.
3. Place only the combination square's head
on the saw's table with its long flat side
resting on the table and its 45° side against
the tilted blade.
4. Place an 8mm open end wrench on bolt
head "F" (see Figure 25).
Adjustments
To avoid possible injury,
disconnect plug from
Adjusting Bevel Stops
5. While turning bolt "F," watch the blade tilt
– turn "F" until the saw blade plate is in full
contact with the 45° side of the square's
head (see Figure 24).
6. If needed, adjust bevel scale pointers (item
36 – page 12) to be in line with the bevel
scale's 45° lines. First, adjust right bevel
pointer; then tilt saw head to the right 45°
stop position (see page 46 – "Bevel Range
2 = 0-45° Right") and adjust the left bevel
pointer. Tilt the saw head to the 0° position
– both pointers should be on the bevel
scale's 0° lines.
7. Push down the bevel lock lever to lock at the
desired bevel angle.
Fig. 25
27