Philips 26HF7955H/27 User Manual page 35

Definitions, Acronyms and Abbreviations
RTP Real-time Transport Protocol. Defines a standardized packet format for
delivering audio and video over the Internet.
Setup Mode See System 7. Remote control mode used to configure Philips Institutional
Televisions for specialized and/or restricted features such as front panel
lockout, volume range, channel list, etc..
SmartPort™ Philips proprietary three-wire synchronous serial communications and
control interface.
SmartPlug™ See SmartPort.
Socket Connector on a cable that connects to socket.
SBB Set-back box. Used interchangeably with "set-top box". General term for a
device that adds functionality to, and / or interfaces a television with, a host
content- and/or control- environment.
STB Set-top box. See SBB.
Stand by Generally referred to as "off". A state of operation, characterized by
relatively low power consumption, in which the unit (television) is
connected to an AC power source, but not in active use, and capable of
responding to queries or commands from a control device and/or DCM.
System 0 First data word of a Philips RC-5 / RC-6 remote control code for standard
television commands. Synonymous with Business Display Solutions / ITV
"guest" mode.
System 7 First data word of a Philips RC-5 / RC-6 remote control code reserved for
specialized commands. Used for Business Display Solutions / ITV "setup"
mode.
TCP Transmission Control Protocol / Internet Protocol. De facto standard
protocol for Internet communications.
UDP User Datagram Protocol. A minimal message-oriented transport layer
protocol that is currently documented in IETF RFC 768. Used by Philips
NetLink to issue device discovery packets.
YPbPr Component video signals consisting of luminance, and blue and red
components.
33