Maintenance And Care - Bissell GARAGE PRO User Manual

Maintenance & Care
Cleaning the dirt tank
1. Unplug the unit from electrical outlet.
2. Remove the dirt tank by pulling up on both
handles to unlatch.
3.
Ensure the dirt tank has been emptied.
4. The dirt tank may be washed in warm
water. Make sure it is completely dry
before reassembling.
5. Reattach the dirt tank to the main unit by
aligning the top of the dirt tank to the upper
portion of the vacuum. Use one hand to hold
the tank and use the other hand to clip the
handles to hold the tank securely.
Cleaning the filters
The filter should be checked every 15-30 days
and washed as needed to maintain performance.
Frequency of cleaning will be based on individual use.
Primary filter
1. Unplug the unit from electrical outlet.
2. Remove the dirt tank by pulling up on both
handles to unlatch.
3. The filter is located inside the top portion of
the vacuum. Pull either black tab towards
the middle of the unit and remove.
4. Shake filter over trash can to release any
loose debris.
5.
Use a damp cloth to wipe the inside and
outside of the filter if desired. Air dry
thoroughly before replacing.
6. To replace, hold one edge of the filter,
collapse and snap in.
7. Reattach the dirt tank to the main unit by
aligning the top of the dirt tank to the upper
portion of the vacuum. Use one hand to hold
the tank and use the other hand to clip the
handles to hold the tank securely.
www.BISSELL.com
10
Maintenance & Care
Cleaning the filters continued
Secondary filter
1.
2.
3.
4.
5.
6.
Clearing clogs
Low suction or poor pickup may be due to a clog
in the vacuum. If this occurs, the LED full dirt
tank indicator light will turn yellow and indicate
airflow is restricted.
If there is no suction or if suction is reduced at
the hose, follow these steps to clear the clog:
1.
2.
3.
4.
If the clog is contained near the top of the hose
(close to the unit), follow these steps:
1.
2.
1-800-263-2535
1-800-237-7691
The secondary filter is located above the
primary filter.
To remove the primary filter, see instructions on
page 10.
To remove the secondary filter, pull filter
down and out.
Shake filter over trash can to release any
loose debris.
Rinse filter with warm water.
To replace filter, insert into top portion of
vacuum.
Unplug vacuum from electrical outlet.
Check the filter and clean as necessary (see
cleaning your filters above and on page 10).
Check to see if dirt tank is full. Empty if
needed.
Check wet/dry or blower outlet for clogs.
Attach hose to the wet/dry inlet and turn the
power on.
This should dislodge the clog by sucking in
debris.
www.BISSELL.ca
11