Troubleshooting; Please Do Not Return This Product To The Store - Bissell GARAGE PRO User Manual

Maintenance & Care
Clearing clogs continued
If the clog is contained near the bottom of the
hose (close to where tools are attached), follow
these steps:
1.
Remove wand or tool.
2.
Attach hose to the blower outlet and turn the
power on.
3.
This should dislodge the clog by blowing out
debris.
If the above methods are not successful, find the
clog by hand, then squeeze the hose and shake
until the debris dislodges.
Tool maintenance
Keep tools clean and free of debris.
1.
Wipe tools clean with damp cloth.
Note: The multi surface floor tool
contains a strip of red material
that should not get wet. If it needs
cleaning, wipe with damp cloth only.
SERVICING OF DOUBLE-INSULATED APPLIANCE
A double-insulated appliance is marked
with one or more of the following: The
words DOUBLE-INSULATION or DOUBLE-
INSULATED or the double insulation symbol
(square within a square).
In a double-insulated appliance, two
systems of insulation are provided
instead of grounding. No grounding
means is provided on a double-insulated
appliance, nor should a means for
grounding be added to the appliance.
Servicing a double-insulated appliance
requires extreme care and knowledge of
the system, and should be done only by
qualified service personnel. Replacement
parts for a double-insulated appliance
must be identical to the parts they replace.
www.BISSELL.com
12

Troubleshooting

Problem
Vacuum cleaner
won't turn on
Vacuum cleaner and
tools won't pick up or
low suction
Other maintenance or service not included in the manual should be performed by an
Thank you for selecting a BISSELL product.

Please do not return this product to the store.

For any questions or concerns, BISSELL is happy to be of service.
1-800-263-2535
1-800-237-7691
WARNING
To reduce the risk of electric shock, turn power switch off
( ) and disconnect polarized plug from electrical outlet
before performing maintenance or troubleshooting checks.
Possible causes
Power cord not plugged in
Blown fuse/tripped breaker in home
Thermal protector activated
Dirt tank is full of water
Dirt tank is full of debris
Hose not properly positioned
Dirt tank not installed properly
Dirt tank full
Clog in cleaner
Filters are dirty
Hose not properly attached
Vacuum is not suctioning or blowing
authorized service representative.
U.S. Consumers : 1-800-237-7691
Canada Consumers : 1-800-263-2535
Monday – Friday 8am - 10pm ET
Saturday 9am - 8pm ET
Sunday 10am - 7pm ET
Remedies
Check electrical plug
Check/replace fuse or reset breaker
Allow cleaner to cool for 30 minutes,
see pg 8. This will reset thermal
protector
Empty tank and reattach
Empty tank and reattach
Make sure hose is fully connected
to base
Check assembly of upper and lower
portions, correctly position and secure
into place
Empty dirt tank
Follow instructions on pg 11 and 12 for
clearing clogs
Check and clean filter
Make sure hose collar is pushed in
or in locked position
Make sure hose is in correct inlet/
outlet
www.BISSELL.ca
13