Protocol Enveloping Definition For An End-User Device (Screen Ci23.4) - IBM 3708 Planning And Installation

Protocol Enveloping Definition for an End-User Device (Screen
C123.4)
Full Duplex Line
This screen continues the port definition for an end-user device if protocol
enveloping or dynamic mode is to be used with it.
C123.4
37a8 PROTOCOL ENVELOPING FOR PORT 7
TYPE ANY DESIRED CHANGES :
I FULL DUPLEX LINE
a IGNORE PARITY
I ECHOPLEX
a DELAY AFTER RECEIPT OF CR
I ALLOW TERMINAL BREAK
aaa LINE QUIET TIME
aaa TEXT TIME OUT
a FULL DUPLEX CONTROL UNIT
6F PARITY ERROR SUB. CHAR.
4F ATTENTION KEY SUB. CHAR.
I RECOGNIZE TERM. ATTENTION
a DELETE RUBOUT CHARACTER
3 RECOGNIZE SYSTEM REQUEST SIMULATION
I PERMANENT REQUEST TO SEND
aD2saaaaaa TURN AROUND CHARACTERS
aD2SCSDSE3CSD94aC4CIE3CI7AaD2saaaaaaaaaa SEND READ PROMPT
PRESS "ENTER" TO CONTINUE OR "PF2" TO QUIT
4BMYJOB
[1,0]
I-Full duplex
O-Half duplex
P aa
This field defines the line from the device to the 3708 as either a full or half duplex
facility.
Note:
Many modems provide a full duplex communication facility over two-wire
telephone lines.
Full Duplex Control Unit
This option defines whether communication to the device is full or half duplex mode.
[1,0]
I-Full duplex
O-Half duplex
(
If the line is half duplex, the control unit must be in half duplex mode. Terminals
are normally configured as half duplex control units even when operating on a
full-duplex facility.
13-36
3708 Planning and Installation