Philips FW880PP/22 Instructions For Use Manual page 16

FW880P-880W/22-Eng 6/15/00
CD
3 CD Direct Play
You can play a CD directly by pressing the 3 CD DIRECT
PLAY (1 - 3) buttons. The CD player will stop at the end
of playback of the selected disc.
– When the button is green, it indicates that there is no
disc loaded in the disc tray.
– When the button is red, it indicates that there is a
disc loaded in the disc tray.
Playing a CD
1 Press PLAY É to start playback.
™ The disc tray, track number and elapsed playing
time of the current track appear on the display.
™ The current track number will also be flashing on
the circular music calendar.
™ When a track has been played, the track number
will be erased from the circular music calendar.
• To interrupt playback, press PAUSE Å.
™ The playing time flashes.
• To resume playback, press PLAY É again.
2 To stop playback, press STOP Ç.
Note:
– All the available discs will be played once, then stop.
When the CD has stopped playing, the system will
switch to the standby mode after 15 minutes if no
button is pressed.
16
4:07 PM Page 16
Disc Change
You can change the outer 2 discs while the third inner
disc is at the stop or playing mode.
1 Press DISC CHANGE.
™ The CD compartment slides out.
2 Replaced the discs in the left and right disc trays.
• If you press DISC CHANGE again during playback,
the CD will stop playing.
™ The CD carousel will rotate until the inner tray is
at the left hand side and is ready for changing.
3 Press OPEN•CLOSE to close the CD compartment.
Selecting a desired track
Selecting a desired track at the stop mode
1 Press PREV í or NEXT ë until the desired track
appears on the display.
2 Press PLAY É to start playback.
™ The selected track number and elapsed playing
time appear on the display.
Selecting a desired track during playback
1 Press PREV í or NEXT ë until the desired track
appears on the display.
™ The selected track number and elapsed playing
time appear on the display.
• If you press PREV í once it will skip to the
beginning of the current track and play the track
again.
Note:
– You can also key in the track number directly from the
remote control.
Searching for a particular passage
during playback
• Press and hold à or á until the desired passage is
located.
™ The volume will be reduced.
• Play returns to normal when à or á is released.
Programming Tracks
Programming tracks of a loaded CD is possible in the
stop mode. The display will indicate the total tracks
stored in the program. Up to 40 tracks can be stored in
the memory in any order. When 40 tracks are stored and
you attempt to store another track, the display will show
"PROGRAM FULL".
1 Load the desired discs in the disc trays.
2 Press PROGRAM to start programming.
™ The PROGRAM flag starts flashing.
3 Press the CD (CD 1•2•3) button to select the disc.
4 Press PREV í or NEXT ë to select the desired
track.
• You can also key in the track number directly from the
remote control.
5 Press PROGRAM to store the track.
• Repeat steps 3 to 5 to store other discs and tracks.
6 Press STOP Ç once to end programming mode.
™ The total number of tracks programmed and total
playing time appear on the display.