Chapter 4
•
To set Daylight Saving:
1. Select
Enable
DaylightSaving.
2. Select the start time from the drop-down list in the
3. Select the end time from the drop-down list in the
4. Click Save.
Note:
This setting will be used for some time-based functions such as firewall. You must specify your time zone once you log
in to the router successfully; otherwise, time-based functions will not take effect.
4. 18. 2. LED Control
The LED Control allows you to turn on or off the LEDs on your device according to a
specific time schedule.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
System Tools
3. Enable the
Night
Mode.
4. Set the
LED Off Time
4. 18. 3. Diagnostic
Diagnostic is used to test the connectivity between the router and the host or other
network devices.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to
System Tools
>
LED
Control.
and click Save.
> Diagnostic.
Configure the Router
Start
field.
End
field.
60