ADC 600F User Manual page 42

Saving the Configuration
Listed in the table below are the default values for the Megabit Modem in PPP over ATM mode.
Reference this table to learn the values assigned to the modem after resetting it to factory
default.
Parameter
System Mode
TFTP parameters
TFTP Server IP Address
TFTP Server Net Mask
TFTP Server Path
File Name
Admin IP Address
PPP Over ATM WAN Configuration
Service Name
ATM VPI
ATM VCI
Login Name
Login Password
Chap Host
Address Translation
Address Assignment
IP Address
User Assignments (for PPP WAN)
Service Name
User's IP Address
32
Default Value Parameter
System Setup
PPP over ATM SNMP parameters
Enable trap sending
192.168.0.2 Trap Server IP Address
255.255.255.0 Trap Server Net Mask
blank field Trap Community String
tiger.bin Get Community String
0.0.0.0 Set Community String
PPP Over ATM
PPP Over ATM LAN Configuration
blank field IP Address
0 IP Net Mask
100 DHCP
blank field Start DHCP IP Address
blank field End DHCP IP Address
blank field Primary DNS
Enabled Gateway
Dynamic Static NAT Entries (private, proxy, and remote)
0.0.0.0 IP Addresses
Ports
blank field Protocol
0.0.0.0
Megabit Modem 400F, 500L, 600F, and 700F User Manual
Default Value
Not enabled
0.0.0.0
255.255.255.0
public
public
private
192.168.0.1
255.255.255.0
Enabled
192.168.0.2
192.168.1.1
192.168.0.1
192.168.0.1
0.0.0.0
0
UDP