Side-Discharging The Clippings - Toro TimeMaster 21199 Operator's Manual

Installing the Grass Bag
1. Raise and hold up the rear door
1
3
2
Figure 25
1. Rear door
2. Rear-discharge plug
2. Remove the rear-discharge plug by pulling down on the
latch with your thumb and pulling the plug out from
the machine (Figure
3. Install the bag rod into the notches at the base of the
handle and rock the bag back and forth to ensure that
the rod is seated at the bottom of both notches; refer
to Figure 26.
1
Figure 26
1. Bag rod
4. Lower the rear door until it rests on the grass bag.
Removing the Grass Bag
To remove the bag, reverse the steps in
Bag (page 15).
(Figure 25).
G017408
3. Latch
25).
2
G016513
2. Notch (2)
Installing the Grass
Side-Discharging the
Clippings
Use the side discharge for cutting very tall grass.
If the bag is on the machine, remove it and insert the
rear-discharge plug; refer to
15) before side-discharging the clippings.
Important: Ensure that the rear-discharge plug is in
place before you recycle the clippings
Installing the Side-Discharge Chute
1. Lift open the side-discharge door
g017408
2
1. Side-discharge door
2. Install the side-discharge chute as shown in
and Figure
g016513
G017522
15
Removing the Grass Bag (page
(Figure
(Figure
1
G017521
Figure 27
2. Side-discharge chute
28, and close the door onto the chute.
Figure 28
24).
27).
g017521
Figure 27
g017522