Zenith Hydroboil Series Installation And Operating Instructions Manual page 13

2.2 SETTINGS – TEMPERATURE
The water temperature can be adjusted as desired. The default
value is 98.0°C. A higher value will consume more energy and
may cause unwanted steam. For values above 95°C a boiling
calibration is recommended (see section 3.2).
From the home screen touch
Touch the , (Inc/Dec) to adjust the water temperature.
2.3 SETTINGS – SLEEP MODES
Zenith Hydroboil can be programed to automatically save
energy when not in use.
For example, when not used for 2 hours, when it is dark (at
night), or at programmed times of the day/week. These are
called sleep modes.
From the home screen touch
► Sleep Trigger - Choose the event that activates the sleep
mode.
► Sleep Action - Choose between 68°C or no heating, when
the unit is asleep.
► Timer - Choose the time and day the unit sleeps if the cor-
responding sleep trigger is set.
2.3.1 SETTINGS – SLEEP MODES – SLEEP TRIGGER
This is the event that causes the unit to begin sleeping (save
energy).
When the unit is asleep, the home page will be shown in dark
grey and the appropriate sleep icon will be shown (see sleep
screen in section 1.1).
804546NZ - BW_HB Small_09.18 v1.02
Menu Operation
, , [Temperature]
, , [Sleep Modes]
From Home screen touch
Touch the required trigger (shown as
► Off – The unit will not enter sleep mode.
► Timer – It will sleep according to the on/off timer settings
(see section 2.3.3).
► Ambient Light – It will sleep when the room is dark (see
section 3.1).
► 2 Hours No Usage – It will sleep after water has not been
dispensed for 2h.
► Usage & Light – It will sleep when water has not been
dispensed for 2h or when it is dark.
Note: The dark and light thresholds are set using light
calibration (see section 3.1).
2.3.2 SETTINGS – SLEEP MODES – SLEEP ACTION
This sets the type of heating (water temperature) when the unit
is asleep (energy saving).
From the home screen touch
Action]
► 68°C – The water temperature setting will be reduced to
68°C when asleep.
► Turn Off – The water will not be heated when asleep.
2.3.3 SETTINGS – SLEEP MODES – TIMER
This determines the time and week day to automatically wake
and sleep to save power.
Remember to also choose "Sleep Trigger" as "Timer" to use
this option (see section 2.3.1).
, , , [Sleep Trigger]
).
, , , [Sleep
Page 13 of 24