Chapter 5 Wiring Option; Cable/Connector Sets; Combinations Of Cable/Connector Sets - Mitsubishi Electric Melservo-Jet HG-SNS Series User Manual

5
WIRING OPTION
Precautions
• Use specified options. Otherwise, it may cause a malfunction or fire.
• MR-J3SCNS(A) and MR-ENCNS2(A) connector sets are packed with a plug and contacts. As using contacts for other plugs
may damage the connector, use the enclosed contacts.
• Correctly wire options and peripheral equipment, etc. in the correct combination.
• We recommend using HIV wires to wire the rotary servo motors, options, and peripheral equipment. Therefore, the
recommended wire sizes may be different from those of the used wires for the previous rotary servo motors.
5.1

Cable/connector sets

The indicated IP rating is the cable and connector's protection against ingress of dust and water when the
cable and connector are connected to a rotary servo motor. If the IP rating of the cable, connector, and rotary
servo motor varies, the overall IP rating depends on the lowest IP rating of all components.
Please purchase the cable and connector options indicated in this section for the rotary servo motor. When fabricating an
encoder cable, refer to the following.
Page 100 Fabrication of the encoder cable

Combinations of cable/connector sets

HG-KNS series
Servo amplifier
CN2
CNP1
*1 The battery (available in the near future) is required when constructing an absolute position detection system.
Direct connection type (cable length: 10 m or shorter, IP65)
Junction connection type (cable length: longer than 10 m, IP65)
*1
Junction connection type (cable length: longer than 10 m, IP20)
To 24 V DC power supply
for electromagnetic brake
(13) (14) (15) (16)
(22) (23)
(24) (25)
(26)
(19) (20) (17) (18)
(21)
(11) (12)
(7) (8) (9) (10)
(5) (6)
(1) (2) (3) (4)
Power Electromagnetic
connector brake connector
Rotary servo motor
Encoder
connector
5 WIRING OPTION
5.1 Cable/connector sets
5
35