Introduction to trouble shooting
Introduction to trouble shooting
Introduction
The screen can show messages and errors.
Messages
Message
Conveyor belt full
Logged into remote service
Errors
In case an issue occurs, an error code will be shown on the screen.
This could be an open cover or a paper jam (as shown in the example).
If there is remaining paper pinched between fold rollers or other turning parts, close the covers
and hold the purge button (2). All transport belts and rollers will be switched on until you release
the button.
After taking out the jammed paper or closing the cover, the folder needs to be restarted by
clicking on the exit button (3).
The folder will reboot now and check the paper path again. This takes approximately 20 seconds.
Thereafter, the folder will be ready.
The "key" button (1) gives the technician the possibility to enter the service menu.
Error code list on page
See also
62
Chapter 8 - Trouble shooting
see
Conveyor belt full on page 63
Logged into remote service on page 64
66.