Product Installation Guide - Navien Mate EQM 580 User Manual

Product Installation Guide

To prevent heat loss when using on the floor, please use any kinds of
mattress pads or topper beneath Navien Mate Pad.
1. Insert the mattress pad inside the provided zipper cover.
- If you don't have provided cover, use any other types of pad or thin layer of blanket as a cover.
- Tie up corner ring of the pad and the inner lining of the cover.
There is a risk of low temperature burns when used for a long time without covering the pad.
2. Select the location to install.
- Make sure the distance between heating unit and pad is more than 1ft.
- Placing the heating unit at the same height or slightly higher than the
pad is recommended.
- Do not place the heating unit on uneven floor or soft carpeted area.
(May not operate due to the malfunction of the balance sensor)
3. Connect the hose to the heating unit.
- Untangle the hose and lay it flat.
- Be sure to connect the hose facing Navien logo.
4. Plug the power cord and touch the power button.
- (water storage error code) will be displayed when you set up for the first time.
- The water level indicator will also blink.
5. Fill the heating unit with water.
Prepare the water.
(The amount of water to be filled is approximately 1,500ml for King size,
1,350ml for Queen size, 1,050ml for Single size.
Open the water inlet cap by turning it counterclockwise.
Slowly add the water while checking the water level indicator lamp.
Keep adding the water until the water level indicator lamp goes up to
the highest level and then wait for a brief moment.
As the water is transferred to the pad from the heating unit, the low water level
and water shortage error will be displayed again. Fill with water as done before.
After water filling is complete, close the water cap by turning it clockwise.
The water shortage error code may occur 2~3 times during initial use. Repeat the water replenishment
procedure according to the above instructions until enough water is replenished.
We recommend using distilled water, bottled water, purified water or tap water.
Using tap water may cause partial product discoloration.
If the water touches the safety net inside the water inlet, it can overflow. Be careful to keep the water level
low enough to prevent it from touching the safety net.
For continuous and stable heating, it is recommended to fill water above the second stage (the mid level)
before or while using.
6. Set desired temperature to begin use. Refer to the "Control Panel Features" page for
instructions on setting the temperature.
1ft
Click!
13