IBM 5147-024 Manual page 30

v The external port of an adapter that you confirmed in step 3 on page 12.
v The external port of an internal adapter cable that you confirmed in step 4 on page 12.
Note: Adapters are cabled to the enclosure by using ports at the rear of the enclosure. To learn about
the enclosure ports that are used in the following options, see "Connector locations" on page 30.
v To complete a mode 1 connection of one 5147-024 storage enclosure by using two AA12 or other
straight cables to two adapters in a 5148-22L system, continue with step 13.
v To complete a mode 1 connection of one ESLL or ESLS storage enclosure by using a YO12 cable to
a single FC EJ0J or FC EJ0M SAS adapter, go to step 14 on page 15.
v To complete a mode 1 connection of two ESLL and ESLS storage enclosures by using a YO12
cables to a single FC EJ0J or FC EJ0M SAS adapter, go to step 15 on page 15.
v To complete a mode 1 connection of one ESLL or ESLS storage enclosure by using a YO12 cables
to an FC EJ0L SAS adapter pair or an FC EJ14 SAS adapter pair, go to step 16 on page 16.
v To complete a mode 1 connection of two ESLL and ESLS storage enclosures by using a YO12
cables to an EJ0L SAS adapter pair or an FC EJ14 SAS adapter pair, go to step 17 on page 17.
v To complete a mode 2 connection of one ESLL or ESLS storage enclosure by using a YO12 cables
to two independent FC EJ0J or FC EJ0M SAS adapters, go to step 18 on page 18.
v To complete a mode 2 connection of one ESLS storage enclosure by using X12 cables to two FC
EJ0L SAS adapter pairs or two FC EJ14 pairs, go to step 19 on page 19.
v To complete a mode 4 connection of one ESLL or ESLS storage enclosure by using X12 cables to
four independent FC EJ0J or FC EJ0M SAS adapters, go to step 20 on page 20.
If your SAS configuration requirements are not supported by any of these options, go to step 21 on
page 22.
13. Complete a mode 1 connection of one 5147-024 storage enclosure (A) by using two AA12 or other
straight cables (B) to two adapters (C, D), as shown in Figure 13, and then continue with
"Connecting cables, power cords, and installing covers" on page 22.
Figure 13. Mode 1 connection of one 5147-024 enclosure by using two AA12 or other straight cables to two adapters
14
Power Systems: Installing the Model 024, ESLL, or ESLS storage enclosure