Siemens SCALANCE M-800 Series Getting Started page 51

Required devices/components
Use the following components for setup:
● Connection to SHDSL
– 2 x M826 (additional option: a suitably installed standard rail with fittings)
– 2 x 24 V power supply with cable connector and terminal block plug
● 2 x PC each connected to a SCALANCE M826.
● PST is installed on the PC.
Settings used
For the configuration example, the devices are given the following IP address settings:
Master sta-
tion
Station
Steps in configuration
The following steps are necessary to configure the 4-wire operation
1. Setting up SCALANCE M826 and network (Page 52)
2. Configuring the SCALANCE M826 with the PST (Page 52)
3. Launching Web Based Management (Page 54)
4. Logging in to Web Based Management (Page 56)
5. Configuring SCALANCE M826
The steps are the same for both devices, the only difference being the settings.
– Specifying device information (Page 57)
– Setting the time (Page 58)
– Configuring SHDSL (Page 60)
SCALANCE M-800 Getting Started
Getting Started, 06/2015, C79000-G8976-C337-04
M826
Admin PC
M826
Admin PC
Connecting SCALANCE M-800 to WAN
1.3 Connecting M826 with SHDSL
IP address
192.168.100.1
255.255.255.0
192.168.100.20
255.255.255.0
192.168.100.10
255.255.255.0
192.168.100.40
255.255.255.0
51