Operation; Maintenance; Troubleshooting - Clarke PS105 Operation & Maintenance Instructions Manual

Operation

1. Fitting Sanding Pad.
a) Select pad to be used. (MUST be correct pads with velcro fitting ability).
b) Ensure sander is switched OFF and plug is removed from socket.
c) Line up holes in pad with those on machine pad. (this is necessary for dust
extraction), press pad firmly onto machine pad to secure it.
2. Dust Extraction.
Dust extraction equipment (not supplied) , can be used with your sander, this is possible by
connecting a suitable hose to the outlet port at the rear of the machine just below the
power supply cable entry.
3. Using The Sander.
Holding the sander firmly, insert the plug into the mains socket and switch ON, turn the
sander on by operating the switch on the front of the tool.
Offer sander to workpiece and work slowly backwards and forwards across the area to be
sanded until finished. Remove sander from workpiece and switch OFF. Wait until machine
has stopped completely before putting it down.
Note: Do Not start the sander whilst it is in contact with the workpiece.

Maintenance

Always inspect the tool before use, and ensure it is in top condition.
Ensure all air vents are clear, (use compressed air to clean the machine where possible).
Check the power cable to ensure it is sound and free from cracks, bare wires etc. Avoid
using solvents when cleaning plastic parts, most plastics are susceptible to damage from
the various types of commercial solvents.
All bearings etc., in this tool are lubricated with a sufficient amount of high grade lubricant
for the tools lifetime under normal operating conditions, therefore no further lubrication is
required.
Trouble Shooting
Sander is overheating
This indicates the machine is dirty. Clean the ventilation holes, and blow out with compressed
air or clean with a dry cloth.
Overloading the machine will also cause overheating. Do not use for heavy duty work, and
do not apply excessive pressure.
Excessive sparking occurs
This indicates worn brushes. This problem is quickly remedied but you should consult your
CLARKE dealer for parts and advice.
Sander does not operate when switched ON
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound or blows
repeatedly, consult your CLARKE dealer.
-5-