Operation Mode When Battery Is Low; Mode 1 - Epson TM-P60II Technical Reference Manual

Operation Mode When Battery is Low

The printer acts differently depending on the remaining battery charge and the operation mode when battery is
low.
The printer has two modes and is initially set to the mode 1.
 It is recommended to replace or charge the battery when the remaining battery charge goes
 Replace or charge the battery when the remaining battery charge goes down to the levels S or
 The buzzer beeps five times when the remaining battery charge goes down to the levels L or S.
 The operation mode when battery is low is selectable with the customized value. To set the
 The remaining battery charge is detected before printing starts and the displayed amount is

Mode 1

Battery LED
Level H
Level M
Level L
Level S
Level E
*: Printing may stop in the middle.
down to the level L.
E.
You can disable the buzzer with the memory switches. To set the memory switches, see
ware Settings" on page 48.
customized value, see "Software Settings" on page
then updated. The Battery LED does not indicate the remaining battery charge detected in
real time.
Error LED
48.
: On
Remaining
Printing
battery charge
Approx. 60 ~ 100% Possible
Approx. 20 ~ 60% Possible
Approx. 10 ~ 20% Possible
Approx. below 10% Possible*
Approx. 0% Impossible
Chapter 1 Product Overview
"Soft-
: Flash : Off
Communication
Possible
Possible
Possible
Possible
Impossible
21
1