Technical Specifications - Siemens SIPART PS2 Compact Operating Instructions

6.3 Initializing linear actuators with a stroke range up to 14 mm (0.55 inch)
Prerequisites
1. Set the "1.YFCT" parameter of the positioner to "ncSL".
2. Launch initialization as usual with "INITA".
6.4 Initializing linear actuators with a stroke range > 14 mm (0.55 inch)
Note
Parameter value "ncSLL" is only available for device series 6DR5... with firmware version > C4. Set the value to 90° on
devices of the 6DR5... series with firmware version < C5 (YAGL). This setting is also necessary for devices of the 6DR4...
series. Resultant non-linearity can be corrected by means of the programmable characteristic by setting the parameter value
from "SFCT" to "FrEE" and adapting the interpolation points.
Prerequisites
1. Set the "1.YFCT" parameter of the positioner to "ncSLL".
2. Launch initialization as usual with "INITA".
7

Technical specifications

7.1 Non-contacting position sensor
Additional modules
Travel range
Linear actuator 6DR4004-.N.20
•
Linear actuator 6DR4004-.N.30
•
Part-turn actuator
•
Linearity (after corrections made by
positioner)
Hysteresis
Temperature influence (range:
rotation angle 120° or stroke
14 mm)
Climate class
Storage
•
Transport
•
Vibration resistance
Harmonic oscillations
•
(sine) according to IEC 60068-
2-6
Bumping according to IEC
•
60068-2-29
Torque for cable gland nut made of Plastic
Housing protection type
SIPART PS2 Non Contacting Sensor (NCS)
A5E00097485-09, 09/2014
Without Ex protection
10 ... 130 mm (0.39 to 5.12"); up to 200 mm (7.87") on request
≤ 0.1 %/10 K (≤ 0.1 %/18 °F) for -20 to +90 °C (-4 to +194 °F)
≤ 0.2%/10 K (≤ 0.2%/18 °F) for -40 to -20 °C (-40 to -4 °F)
1K5, but -40 to +90 °C (-40 to +194 °F)
2K4, but -40 to +90 °C (-40 to +194 °F)
3.5 mm (0.14"), 2 to 27 Hz, 3 cycles/axis
98.1 m/s² (321.84 ft/s²), 27 to 300 Hz, 3 cycles/axis
300 m/s
2.5 Nm (1.8 ft lb)
IP68 according to IEC/EN 60529; NEMA 4X / Encl. Type 4X
With Ex protection
Ex "ia"
3 to 14 mm (0.12 to 0.55")
30 ... 100°
± 1 %
± 0.2%
According to DIN EN 60721-3-4
(984 ft/s ), 6 ms, 4000 shocks/axis
2 2
Metal
4.2 Nm (3.1 ft lb)
With Ex protection
Ex "ic", "nA"
Stainless steel
4.2 Nm (3.1 ft lb)
15