Disconnecting Probes From Pods - HP 1650A Setting Up

Disconnecting
Probes
~I
)
From Pods
You can disconnect un-used probes from the pods to eliminate clutter.
'Ib disconnect a probe, insert the tip of a ball-point pen in the latch
opening and push while gently pulling the probe out of the pod
connector as shown below
16SlVD'11
lou re-connect a probe to a pod by insertmg the double pin end of
the probe into the pnd. The probes and pod connector body are both
keyed rchamferedt so that they
will
fit together in only one way,
Connecting logic Analyzer to the Target System
3-3