Wireless Wan - Panasonic FX-55 Series Operating Instructions Manual

Wireless WAN

<Only for model with wireless WAN>
N O T E
Communication is established through the Wireless WAN antenna (A). Do not block the antenna area with your hand or body.
n
To use wireless WAN, set
n
the Setup Utility.
If "Device driver software was not installed correctly." (or a similar message) appears when starting the computer or resuming from
n
sleep or hibernation.
When communication works normally, Wireless WAN is operating correctly.
If communication fails, the device may not be recognized correctly. In this case, restart the computer.
Do not use the nanoSIM card adapter.
n
Do not insert nanoSIM cards on which labels or stickers are affixed. Failure to obey may result in malfunction.
n
Inserting/Removing a nanoSIM Card
Before using the Wireless WAN, set a nanoSIM card to the nanoSIM card slot.
Be sure to turn off the computer before inserting or removing the nanoSIM card.
n
To insert a nanoSIM card
1. Turn off the computer.
2. Disconnect the AC adaptor, remove the battery pack. (
<When using second battery pack>
Remove the second battery pack. (
3. Open the cover (A).
4. Remove the screw (B) and the nanoSIM card slot cover (C).
5. Insert the nanoSIM card (D) into the nanoSIM card slot with the contact side (E) facing downward and with the cut corner oriented as
[Wireless WAN] to [Enabled] (default) in the sub-menu of [Wireless Configuration] in the [Advanced] menu of
I M PO R TAN T
Replacing the Battery
Replacing the Battery Pack)
Pack)