Calibrating The Screen - Panasonic FX-55 Series Operating Instructions Manual

Suitable for finger operation.
Use this mode when not operating with the pen (included).
[Touch (Glove)] mode
Use this mode when operating with a glove on.
Depending on the type of glove, operation may be ignored.
With finger operation, the screen may not respond properly.
3. If a confirmation message appears, click [Yes].
Do not touch the screen while switching the operation mode. Switching may fail by doing so.
n

Calibrating the Screen

When you cannot point correctly with the pen (included) or your fingers, calibrate the screen by following the steps below.
Perform the calibration as an administrator. A standard user needs to perform the calibration as an administrator before performing the calibration for
each user.
N O T E
At first, sign in to Windows as an administrator, and perform this calibration.
n
1. Open "Tablet PC Settings".
Click (Start) - [Windows System] - [Control Panel] - [Hardware and Sound] - [Tablet PC Settings].
2. Click [Calibrate...].
3. Using the pen (included) or finger, touch each of the "+" target marks one by one, and then click [Yes].
N O T E
The following message, "Right-click anywhere on the screen to return to the last calibration point. Press the Esc button to close the
n
tool." will appear on the center of the screen during calibration. However, the operation to close the tool by pressing the ≪ Esc≫ key
can be performed.
If you perform calibration as a standard user, the calibration data is valid until you sign out. (The data becomes invalid after you have
n
signed out.) When using the computer continuously, perform calibration as an administrator.
If you cannot operate the computer correctly after calibration, delete the calibration data by clicking [Control Panel] - [Hardware and
n
Sound] - [Tablet PC Settings] - [Reset...], and perform calibration again. (Be sure to delete the calibration data as an administrator.)
I M PO R TAN T
I M PO R TAN T