Brick And Baffl E Installation - Napoleon S20-1 Installation And Operation Manual

4.4 brick and baffl e installation
WARNING
!
• Operation of the appliance without the bricks and baffl es can result in excessive temperatures that could
damage the appliance, chimney and the surrounding enclosure.
With the appliance and chimney installation completed, move the bricks into place as illustrated below (Fig. 4-3).
Install nine (A) bricks and one (B) brick along the bottom of the fi rebox, working from the back of the
A.
appliance forward.
Install eight (A) bricks along the left and right sides of the appliance.
B.
Install four (A) bricks and one (C) brick along the back wall by pivoting the bricks up under the brick
C.
retainer.
note:
Place brick (C) in the centre, with two (A) bricks on either side as illustrated (Fig. 4-3).
Carefully pivot fi bre baffl es (D) up onto the secondary air tubes as illustrated (Fig. 4-4). Ensure that the
D.
top baffl es are pushed all the way to the rear of the fi rebox, leaving a minimum of a 1 inch gap along the
front. This will allow the fl ue gases to escape the fi rebox. Ensure overlap joint is tight.
Install the two (E) bricks along the front.
E.
A
A
A
A
A
A
A
E
E
note:
The fi bre baffl es are shipped inside the fi rebox. They must be removed from all special packaging prior to installation.
For further details about brick descriptions and part numbers, see "replacement parts" section.
D
D
A
A
A
C
A
A
A
A
A
A
B
A
A
A
A
Fig. 4-3
BAFFLE
A
SECONDARY
AIR TUBES
fi nishing
EN
OVERLAP
JOINT
Fig. 4-4
21
W415-2796 / B / 12.19.19