Door Adjustment; Door Handle Installation - Napoleon S20-1 Installation And Operation Manual

fi nishing
EN
4.2

door adjustment

note:
This hinge pin is an offset cam, which means it can move the door away from or closer to the fi rebox face,
either creating a gap between it and the door gasket or making the door fi t too tight. Adjust accordingly.
After removing and reinstalling the door (see
1.
"door removal" section), the door may not be
level. In this case, door adjustment may be
necessary.
To align the door, loosen the set screws. Rotate
2.
the hinge pins clockwise or counter-clockwise
to raise or lower the opposite end of the door.
Tighten the set screw.
note:
Door adjustment is strictly trial and error; you
may need to perform this adjustment a few
times until the desired door angle is attained.
Ensure the door latch closes and engages
3.
properly.
4.3

door handle installation

WARNING
!
• Burning your appliance in with the doors open or ajar creates a fi re hazard that may result in a house and/or
chimney fi re.
• Do not strike or slam door.
• Never remove the door when the appliance is hot.
Door Handle
Door Knob
20
W415-2796 / B / 12.19.19
Front View
Spring
Washer
Back View
Spacer
Door Latch
Door
Some parts
hidden for clarity.
Hinge
Pin
Set Screw
Allen Key Size:
1/8"
Spring
Washer
Lock Nut