Starting Operation - Bosch IXO Original Instructions Manual

16 | English
Protect the charger against moisture.
u
The battery charge indicator shuts down after 30 seconds if the power tool is not run-
ning.
Changing the tool (see figure B)
Do not use two-sided screwdriver bits that are longer than 25 mm.
u
Insert the screwdriver bit (1) directly into the tool holder (2).
Off-Set Angle Adapter/Angle Screw Adapter (see figures C –
F)
Note: The power tool is not intended for use with the grass shears attach-
ment (1 600 A00 10D).
You can drive in screws close to edges using the off-set angle adapter (14).
The angle screw adapter (15) allows you to drive in screws in hard-to-reach
areas.
Assembly (see figures C – D)
To fit the adapters, pull off the rubber cap (3) towards you. Then the ad-
apters can be attached. The attachments can be mounted offset by 45° re-
spectively.
Removal (see figures E – F)
To remove the attachments, turn the unlocking ring (16) in the rotational
direction ➊ and pull the adapter off towards you. Then reattach the rubber
cap (3).
Operation

Starting Operation

Setting the rotational direction
The rotational direction switch (5) is used to change the rotational direction
of the power tool. However, this is not possible while the on/off switch (8) is
being pressed.
Do not use the rotational direction switch (5) when the power tool is
u
in operation, as this may damage it.
1 609 92A 4W9 | (07.06.2019) Bosch Power Tools